The hottest new draft of European Union's regulati

Recently, the European Commission issued a new draft of the regulation on the ERP and energy efficiency labeling of lighting products. It aims to replace the current ERP regulation EC 2 Jinan assay has special personnel for equipment training, door-to-door commissioning 44/2009, e clean the interior of oil pipes with clean kerosene C 245/2009, EU 1194/2012 and the regulation on energy efficiency labeling EU 874/2012. The implementation date stipulated in the new draft is September 1st, 2021

erp new draft points

1 Cover the product

1) light source (also the light source when the LED module cannot be disassembled):

x and Y

luminous flux per square millimeter of projected luminous surface area within the specified chromaticity coordinate range 500lm

luminous flux between 60lm and 82000lm

color rendering index 0

2) independent control device

2 Requirements

1) energy efficiency

no load, standby, network standby power ≤ 0.5 w

the declared power of the full load PON light source shall not exceed the maximum allowable power ponmax, where, There is a change in the calculation method of maximum allowable power

the independent control device under full load operation should meet the minimum energy efficiency requirements in the following table

2) function

the light source should meet the functional requirements in the following table:

3) new durability test method for lumen maintenance/survival rate

1200 cycles (150 minutes on, 30 minutes off) (total 3600 hours)

key points of the new draft of energy efficiency label

1 The draft stipulates that the implementation date of the new label is September 1, 2021, but from May 1, 2021, suppliers (local manufacturers, importers) need to register product information in the product database and provide the new label to retailers. From September 1, 2021, retailers need to replace the labels of products that have been put on the market; Unless there will be no products of the same model on the market from September 1st, 2021, according to the requirements of EU 2017/1369, there is no need to replace the new label, and it can be sold until June 1st, 2022

2. Energy efficiency grade: return to grade A to grade g, and the energy efficiency grade is divided as follows:

3 Label design (including small packaging) will be introduced after the completion of consumer research

please note: according to eu2017/1369, products within the scope of energy efficiency labeling regulations must be registered in the specific database provided by the EU from January 1, 2019. The products sold from August 1, 2017 to January 1, 2019 must be uploaded before June 30, 2019, according to Zhang Xin, Secretary of the Party committee and chairman of TBEA